Agilent Technologies Turbo-V 2000HT Manual De Instrucciones página 288

17 Technical Information
Use
D
where: XXX = YES or NO.
This function is factory-set to YES.
D
Figure 39
288/306
When the last digit is entered, the display shows:
E L A Y
T H R E
Press the CYCLE NUMBER push-button and select YES if relay
K2 must operate only after the run-up time or select NO when the
K2 operation is needed right from start of the turbopump and
after the rotational speed of the turbopump exceeds for the first
time the speed threshold value (see the preceding cycle diagram).
E L A Y
T H R E
Turbo-V 2000HT Controller User Manual / 87-900-913-01
E V E N
S H O L D
E V E N
S H O L D
A F T E
: X X
A F T E
: Y E S
R
X
R
(O)