Starting the Pump
If the forepump and vent device are not operated by the controller,
close the vent valve and switch on the forepump.
With the FRONT panel operation selected, the REMOTE and RS 232 operations
NOTE
are inoperative; conversely, the CYCLE NUMBER and PUMP CURRENT push-
buttons are always active, even when the operating mode selected is REMOTE
or RS 232 / 422 / 485.
S
Figure 41
Turbo-V 2000HT Controller User Manual / 87-900-913-01 (O)
Press the START push-button (or use the remote or RS 232 start
signal), and the display shows:
O
F
T
[
-
-
S
T
A
R
T
-
-
-
-
-
Technical Information
Use
O
N
-
-
-
]
291/306
17