Connection J21 - Accessories And Options Interconnections - Agilent Technologies Turbo-V 2000HT Manual De Instrucciones

17 Technical Information
Interconnections
Connection J21 – Accessories and
Options Interconnections
Figure 12
The 120 Vac, 1 A maximum (independent of line Voltage) output
Voltage is present when the main power switch is set to 1 position
and after START push-button is pressed and will remain present
until a fault condition is displayed on the front panel display or the
turbopump is stopped.
The connector J21 is a power output for vent device, forepump relay
coils.
To make connections, remove the plug and wire the pins (maximum
wire size 18 AWG, 1 mm²) as indicated in the figure to obtain the
desired capability.
Forepump relay coil is an independent user supplied item.
NOTE
250/306
J21 connectors
Turbo-V 2000HT Controller User Manual / 87-900-913-01 (O)