Brill 40 BT Manual De Instrucciones página 26

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
Fault
GB
Lawnmower does not run smoothly
or vibrates vigorously.
Motor does not start.
Motor starts for a short time then
suddenly stops with a loud bang.
Aerator roller is not operating with
the blade (only 40 BHC).
Lawn turning yellow,
cut not clean.
Mower leaves deep tracks.
Wheel drive not functioning.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices (switch
handle, safety covers) and / or
if the cutting device is damaged
or worn. Never disable safety
devices.
Check the work area before
starting work. Remove any
foreign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear strong shoes and
long trousers whilst working.
26
Possible Cause
Blade damaged (out of balance),
cutter bar fixings at motor shaft
loose.
Primer was not operated
when starting the motor.
No fuel, fuel tank empty.
Spark plug defective or
fuel tank empty.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Rotary switch at 0 position.
V-belt torn.
Blade is too blunt,
cutting height too low.
Ground softened by water,
lawn too wet.
Drive belt broken.
Clutch cable stretched.
Do not work barefoot or in light-
weight sandals.
Warning! Petrol is extremely
inflammable. Only keep petrol in
the container provided for the pur-
pose. Always fill the tank outdoors
and do not smoke when filling the
tank with petrol. Fill up with
petrol before starting the engine.
Stop the engine before topping up.
Never open the tank cap or top up
with petrol whilst the engine is run-
ning or the equipment is hot.
For safety reasons, do not attempt
to start the engine if the petrol
has overflowed. Instead, remove
Remedy
Tighten bolts for blade.
Damaged parts must be replaced
at an authorised service centre.
Press the primer several times
(see Putting your Lawnmower
into Operation).
Clean spark plug and / or
fill the fuel tank.
Motor overhaul at specialist
workshop required.
Turn rotary switch to 1 with the
motor switched off.
V-belt must be replaced by
specialist workshop.
Change blade and / or use
a slightly higher cutting height.
Allow lawn to dry, do not mow
if grass is wet.
Drive belt is to be replaced.
Obtain assistance from
a Brill Service Station.
Readjust the clutch cable.
the equipment from the area con-
taminated with petrol. Doe not
make any attempt whatsoever
to start the engine until all the
petrol vapours have evaporated.
For safety reasons, the petrol tank
and tank cap must be replaced if
damaged.
Always replace damaged exhaust
components.
Check the cutting tools regularly for
damage and have them repaired
correctly if necessary.
Only have cutting tools replaced
by Brill Service or your authorised
specialist dealer.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

40 brt40 bc40 brc46 bc46 brc40 bhc

Tabla de contenido