Amann Girrbach ceramill argotherm 2 Modo De Empleo página 57

▷ Carefully position the sintering bowl into the
furnace compartment and place it into the
recess of the sintering base.
Fig. 31
▷ Using the bowl/cover tongs, pick up the protec-
tive gas retort by the lateral pins.
Fig. 32
The protective gas retort can be placed on
easier, when it pivots freely in the tongs.
A P P L I C A T I O N A N D O P E R A T I O N
NOTE:
Make sure there are no coarse debris particles
on the sealing surface or on the bottom edge of
the retort, which could influence the tightness
and the proper seating.
To ensure that the fit and tightness is
always the same:
▷ Always place the gas retort with the tri-
angular arrow head on into the furnace
compartment and onto the base.
▷ Carefully guide the protective gas retort into
the furnace compartment and lower it over the
sintering bowl without applying pressure.
Fig. 33
E N
57