Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Procedure
1. Remove the four screws (1) from the instrument.
2. Locate the instrument in panel mount assembly.
3. Secure with the four screws (1).
4. Support the instrument and connect the cables and pipes.
5. Refer to the electrical connections below before fitting the instrument into the panel.
6. Secure the instrument in the panel with four screws and washers (2).
5 Electrical connections
WARNING
THE GROUND LEAD OF THE INSTRUMENT MUST BE CONNECTED TO THE AC SUPPLY
PROTECTIVE SAFETY GROUND.
ISOLATE THE POWER SUPPLY BEFORE MAKING ANY ELECTRICAL CONNECTIONS TO
THE REAR PANEL.
CAUTIONS
Use the power adaptor supplied with the instrument (GE part no. 191-370). Using
other power adaptors may cause over-heating, this can result in a fire.
Do not let the power adaptor come into contact with any moisture or liquids.
K0467 Revision A
Figure 6 Panel-mounting
11
[EN] English
Publicidad
Tabla de contenido
