Machine Control Panel Fusion 20 Ix - Clarke FUSION 20I Libro De Instrucciones

MACHINE CONTROL PANEL (Fusion 20 IX)
Key Switch (See Figure 11, Item "A")
The key switch turns "ON" the power to the control
panel. "O" is "OFF" and "I" is "ON".
Forward Reverse Switch (See Figure 11, Item "B")
The forward/reverse switch turns the traverse motor
"on" forward and starts the pad motor. There is a two
second delay for the pad motor to stop after releasing
the switch. Either the right or the left switch can be
used. Use either switch in conjunction with the white
reverse switch to reverse the traverse motor.
Reverse Switch (See Figure 11, Item "H")
The reverse switch, when used in conjunction with
one of the forward/reverse switches, causes the
machine to reverse directions. The reverse speed is
70% of the forward speed.
Battery Meter (See Figure 11, Item "C")
The battery meter indicates the relative charge on the
battery pack. Do not continue to run the machine
when the needle is in the "red" area. This will
shorten the life of the battery pack.
Pad Pressure Meter (See Figure 11, Item "D")
The pad pressure meter indicates the relative amount
of pressure the pad is putting on the floor. To
maximize run time on a battery charge, keep the
needle towards the center of the green area.
Figure 10A
Page -22-
Hour Meter (See Figure 11, Item "E")
The hour meter indicates the number of hours of the
machine has operated. It runs only when the
machine is moving forward or reverse.
Circuit Breakers (See Figure 11, Items "F" and
"G")
The circuit breaker reset buttons are located on the
rear cover. The breakers are located as follows:
Item F - Pad Motor (70 amp)
Item G - Traverse Motor (25 amp)
If a circuit breaker trips, determine which motor is not
operating and turn the key switch "OFF". Wait five
minutes and push the reset button back in. Turn the
key switch "ON", and try again. An authorized
service person should be contacted if the breaker
trips again.
Control Handles (See Figure 11, Item "I")
The control handles are located at the rear of the
machine. They are used to guide the machine.
Parking Brake. See Figure 12a & 12b.
The parking brake prevents movement of the ma-
chine. It is located at the rear lower left side of the
machine. To engage the brake, push the pedal down
(Figure 12a). To release the brake, lift pedal up
(Figure 12b).
CAUTION:
Figure 9
Clarke ® Operator's Manual -Fusion 20 Burnisher
Do not activate the brake while
the machine is moving.
Figure 10B