Morningstar SUNSAVER DUO Manual De Instalación Y Operaciones página 8

Wiring
Three system wiring examples are provided for RV's and caravans,
boats, and non-mobile installations. Reference the appropriate wiring
diagram for your installation.
CAUTION: Protect system wiring from sharp edges and foot
traffic. Use grommets and wire loom where necessary.
3. 4 W i r i ng
NOTE: Power connection order is not critical. A connection
Three system wiring examples are provided for RV's and caravans, boats, and non-
order has been provided for each installation type for
mobile installations. Reference the appropriate wiring diagram for your installation.
instructional purposes only.
C A U TI O N : Protect system wiring from sharp edges and foot traffic. Use gromme
NOTE: Wiring charts on page 17 of this manual provide
wire loom where necessary.
minimum recommended wire size.
N O TE: Power connection order is not critical. A connection order has been prov
RV / CARAVAN INSTALLATION
for each installation type for instructional purposes only.
A wire jumper is installed across the Remote Temperature
N O TE: Wiring charts on the back page of this manual provide minimum
Sensor (RTS) terminals at the factory. The jumper can
recommended wire size.
prevent false RTS detection due to condensation on the
SunSaver Duo. Do not remove this jumper unless an
optional RTS is to be installed.
R V / C A R A VA N I N STA LLA TI O N
Figure 4. Typical RV / Caravan wiring diagram
Figure 4. Typical RV / Caravan wiring diagram
N O TE:To ensure good vehicle chassis ground connections:
Before proceeding, mount the solar module(s) per the manufacturer's instructions. If
adding batteries that are not factory installed, they should be safely secured in their
- remove all paint, grease, debris at grounding point.
- use sandpaper/emory cloth to expose chassis bare metal.
- use ring terminal and star- or lock-washer to secure cable.
- dielectric grease can be used to minimize corrosion.
8