Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
NOTE: When mounting the SunSaver Duo, ensure free air
flow through the controller heat sink fins. There should be
3. 3 M ount i ng
at least 3 inches (75 mm) clearance above and below the
controller to allow for cooling. If mounted in an enclosure,
N O TE: When mounting the SunSaver Duo, ensure free air flow through the con
ventilation is highly recommended.
heat sink fins. There should be at least 3 inches (75 mm) clearance above and b
the controller to allow for cooling. If mounted in an enclosure, ventilation is highly
WARNING: Never install the SunSaver Duo in a sealed
recommended.
enclosure with vented (flooded) batteries! Do not install in
W A R N I N G : Never install the SunSaver Duo in a sealed enclosure with vented
a confined area where battery gasses can accumulate.
(flooded) batteries! Do not install in a confined area where battery gasses can
RISK OF EXPLOSION!
accumulate. Risk of explosion!
1. Locate the SunSaver Duo on a vertical surface protected from direct
sun, high temperatures, and water.
1. Locate the SunSaver Duo on a vertical surface protected from direct sun, high
temperatures, and water.
2. Place the SunSaver Duo in the location where it will be mounted.
2. Place the SunSaver Duo in the location where it will be mounted. Verify that
Verify that there is sufficient room to run wires and that there is
there is sufficient room to run wires and that there is ample room above and
ample room above and below the controller for air flow.
below the controller for air flow.
Figure 3. Mounting and cooling
Figure 3. Mounting and cooling
3. Use a pencil or pen to mark the four (4) mounting hole locations on
3. Use a pencil or pen to mark the four (4) mounting hole locations on the mounting
surface.
the mounting surface.
4. Remove the controller and drill 3/32" (2.5 mm) holes in the marked locations.
4. Remove the controller and drill 3/32" (2.5 mm) holes in the marked
5. Place the controller on the surface and align the mounting holes with the drilled
locations.
holes in step 4. Secure the controller in place using the mounting screws
(included).
5. Place the controller on the surface and align the mounting holes with
the drilled holes in step 4. Secure the controller in place using the
mounting screws (included).
11
7
Publicidad
Tabla de contenido
