Setting The Unit Of Measure - Leica PINMASTER Manual De Instrucciones

SETTING THE UNIT OF MEASURE

The Leica Pinmastercan be set to meters or yards, the
more commonly used unit in the USA.
Setting:
1. Briefly press (<3s) the main button (2).
• The target mark appears.
2. Press and hold (≥3s) the secondary button (1).
• EU.US appears below the target mark.
3. Briefly press the main button.
• EU disappears, the target mark and US continue to
flash.
4. Select your preferred units of measure by
(repeatedly) pressing the secondary button. US
stands for the unit yards, EU for meters.
• The respective displays continue to flash.
5. Save your setting by briefly pressing the main
button.
• The saved setting and the target mark light up
continuously for 2 seconds for confirmation and
then disappear.
Notes:
• The current setting can always be seen in the
display -if meters are selected, a dot appears to
the bottom right of the target mark.
• Concerning the setting process: The displays
disappear 3 seconds after you last press one of the
two buttons. The previously saved setting is
retained.
EN
23