Creating Profiles - Leister VARIANT T1 Instrucciones De Funcionamiento

2. Profile Setup

2.2 Creating Profiles

• The Profile Setup allows you to create 7 individual profiles for
which the name, and all three parameters Drive
Blower can be freely set and then saved by pressing the
e-Drive (Fig. 21).
6
• The various menu items can be selected using the controls (4). Pres-
sing the e-Drive
62
• Turning the e-Drive
display (5) at the bottom.
Right arrow
1
Left arrow
• If the ABC
e-Drive , you will be taken back to the menu Profile Name
by pressing the e-Drive
• In the Profile Name menu, you can turn the e-Drive
the characters _ / . / A to Z / 0 to 9, as well as the left or
right arrows and the symbols Save
• Change profile name
– If you turn the e-Drive
If the right arrow is selected by pressing the e-Drive
position in the profile name will jump one character (black) to the
right. If you activate the left arrow by pressing the e-Drive
position in the profile name will jump one character (black) to
the left (Fig 23).
– Turning the e-Drive
( _ / . / A to Z / 0 to 9) to be selected. If you press the e-Drive
the character shown black in the profile name will now be replaced by
the character previous selected.
• Save or reject profile name
– If the Save
Save
the profile name will be saved by pressing the e-Drive
– If the Back
the profile name will be rejected (not saved) by pressing the e-Drive
Carry out a test weld according to the welding instructions of the material manufacturer and
national standards or directives. Check test weld.
2.3 Standby Setup
• The standby times defines the time that has to pass (no buttons pressed, welding
nozzle (9) not in welding position) before the cooling process (see Section 1.8
Cooling) is automatically triggered.
– Turning the e-Drive
40 minutes are set at the factory.
• Pressing the e-Drive
will take you back to the Profile Setup selection.
activates left or right arrows on the
by pressing the e-Drive
by pressing the e-Drive
%
symbol is activated by turning the
(Fig. 22).
Save
you can select the left or right arrows.
allows the required character
symbol is selected by turning the e-Drive
symbol is selected by turning the e-Drive
allows the time to be set from 5 to 120 minutes.
will take you back to the Profile Setup selection.
, Heating ,
to the next page (Fig. 15).
to the previous page (Fig. 16).
to select
or Back .
, the
, the
.
1
2
3
(Fig. 21)
6
62
1
G
U X Y Z
2 3 4 5
,
,
.
%
(Fig. 22)
1
J K
S T
6 7 89
Save
(Fig. 23)
33