1. Work Mode
1.5 Setting the air volume
• The air volume can be changed with the Blower
set in 5% increments from 40% to 100% by turning the e-Drive
accepted after 3 seconds, as long as no button is pressed within these 3 seconds. If
the air volume is set to 100%, no information will appear on the display (5) (Fig. 12).
• If this menu is called up from the Setpoint Value display, the heating and blower
can be started by pressing the e-Drive
• The Cool Down menu can be selected by pressing the e-Drive
(Section 1.8 Cooling).
• You can change to the relevant menu using the Drive
1.6 Length Measurement, Blower and Drive Counter
• This menu (Fig. 13) appears if the Drive
• The menu displays all operating times and the distance which the device has travelled
since being switched on. The total distance (here: 1034 m) cannot be changed and
shows the entire path taken since being put into operation.
• The daily distance (here: 012 m) is not reset automatically, but instead can be reset to
zero by the user via
• The Time values concern the operating time for the individual components of the
device. The time is assigned to the blower «Blow» (here: 043:58) and the drive «Drive»
(here: 020:10). The «Total» time refers to the operating time. It counts the hours and minutes (here: 143:12)
during which the main switch (3) is switched on.
• If the Back arrow
from which the Drive
30
by pressing the e-Drive
Reset
is selected by pressing the e-Drive
button has been pressed.
button. The air volume can be
.
or Heating
button is pressed for at least 3 seconds.
.
6.0
.The setting is
620
100
button.
, you will be taken back to the menu
%
(Fig. 12)
Reset
(Fig. 13)