Placing & Answering Calls - Clarity XLC3.4+ Manual Del Usuario

PLACING & ANSWERING CALLS
TO PLACE A CALL:
1. Press , then dial the number
using the numeric keypad. See lighting
pattern for the TALK button on the
bottom of the page.
2. Adjust the volume to the most
comfortable level - using the Volume
Control and BOOST button (if
necessary).
3. Press the
of the handset to adjust the tonality
of the incoming voice to the most
comfortable level.
1. If the Voice Assist function is enabled,
you will hear the digits of the
incoming phone number.
2. Step 1 above can be replaced with
one of the following options:
• Dial from CID records: Choose a
record from your Caller List (see
page 17), then press
• Dial from PHONEBOOK: Choose a
record from your Phonebook (see
page 18), then press
• Pre-dial: before pressing
dial the number you wish to call;
digits will display on the screen;
press when the number is
complete.
Follow with steps 2-3 above to
enjoy a clear and comfortable phone
conversation.
button on the side
!
.
.
,
TO ANSWER A CALL:
1. When phone is ringing, press
to answer the call.
2. Adjust the volume and tone of the
incoming voice according to your
preferences.
3. When finished, press
up.
1. For an explanation of the TALK
button light, see the bottom of the
page.
2. If you have CID service, note the
incoming phone number displayed on
your screen.
3. If the Voice Assist function is enabled,
you will hear the digits of the
incoming phone number.
4. At any point during the conversation,
press the speakerphone button
to switch to handsfree mode. Use
the volume control for adjusting the
level of the incoming audio. Switch
back to earpiece mode by pressing
the speakerphone button again.
Green: Phone is in use.
Flashing Green every 15 seconds in
standby mode: Low batteries.
E
N
G
L
I
S
H
to hang

15