Placing & Answering Calls - Clarity XLC3.4+ Guia Del Usuario

PLACING & ANSWERING CALLS
XLC3.4+
TO PLACE A CALL:
Press TALK, then dial the
1.
number using the numeric
keypad. See lighting pattern for
the TALK button on the bottom
of the page.
2. Adjust the volume to the most
comfortable level - using the
Volume Control and BOOST
button (if necessary).
3. Press the TONE button on the
side of the handset to adjust the
tonality of the incoming voice
to the most comfortable level.
WARNING: VOLUME MAY BE LOUD!
NOTE:
1. If the Voice Assist function is
enabled, you will hear the digits
of the incoming phone number.
2. Step 1 above can be replaced
with one of the following
options:
• Dial from CID records: Choose a
record from your Caller List (see
page 20), then press TALK.
• Dial from PHONEBOOK: Choose
a record from your Phonebook
(see page 21), then press TALK.
Pre-dial: before pressing TALK,
•
dial the number you wish to call;
digits will display on the screen;
press TALK when the number is
complete.
Follow with steps 2-3 above to
enjoy a clear and comfortable phone
conversation.
TO ANSWER A CALL:
1. When phone is ringing, press
TALK to answer the call.
2. Adjust the volume and tone of
the incoming voice according to
your preferences.
3. When finished, press TALK to
hang up.
NOTE:
1. For an explanation of the TALK
button light, see the bottom of
the page.
2. If you have CID service, note
the incoming phone number
displayed on your screen.
3. If the Voice Assist function is
enabled, you will hear the digits
of the incoming phone number.
4. At any point during the
conversation, press the
speakerphone button
switch to handsfree mode. Use
the volume control for adjusting
the level of the incoming audio.
Switch back to earpiece mode
by pressing the speakerphone
button again.
Talk Button Lighting Pattern
Green: Phone is in use.
Flashing Green every 15 seconds in
standby mode: Low batteries.
E
N
G
L
I
S
H
to

15