Bosch REXROTH CSS/B Manual Del Usuario página 59

3 842 540 837 (2010.02)
If only dismantling the motor, begin with
step 7.
1 Loosen the screws at the drive shaft.
2 Lift the entire drive unit out steadily,
taking care to keep it level.
3 Remove the toothed belt at the side.
4 Disconnect the hexagon shaft.
5 Loosen the two hexagonal screws
M6 (WS8) on the fl ange.
6 Remove the gear motor from the
hexagonal shaft.
7 Loosen the four hexagonal screws
M5 (WS8) with locking washers on
the gear fl ange.
8 Remove the motor from the gear
fl ange.
Assemble in reverse order.
9 Remove the yellow protective cap
"X" from the motor shaft on the new
motor.
10 Grease the motor shaft and
hexagonal gear shaft before
assembly. The hub of the new gear
has already been greased at the
factory.
Do not forget the cover tube!
Installing the drive unit:
Lower steadily into the subframe, taking
care to keep it level and ensure that the
toothed belt sits in the gear teeth of
the toothed belt wheel!
TS 2pv
9.2.2 Replacing the motor or gear,
interior motor mounting
The CD MTparts 3 842 529 770 contains video tutorials about changing motors,
gears, and toothed belts, which can be found under "Maintenance Video for TS
2plus".
Bosch Rexroth AG
1
(4x)
SW4
5
M = 4 Nm
D
(2x)
SW8
M = 5 Nm
D
7
SW8
M
D
2
27
DE
10
(4x)
EN
gleitmo 585K
= 5 Nm
FR
4
ES
PT
CSS/BM
3
10
Antiseize
"X" 9
8
Fig. 9
IT