Commissioning; Commissioning For The Fi Rst Time - Bosch REXROTH CSS/B Manual Del Usuario

20 Bosch Rexroth AG
CAUTION!
NOTE!
NOTE!
7

Commissioning

Only commission the belt section if all safety devices have been installed in
the system and are functional. The user must equip the transfer system with an
emergency-OFF device! Accident prevention regulations of the German Employers'
Liability Insurance Association, continuous conveyors, VBG 10.
Make sure that all electrical and pneumatic connections are either used or covered.
Make sure that all screwed connections and plugs are properly connected. All of the
relevant protective covers must be assembled.
Commission the product only if it is installed completely.
Unexpected movements, falling conveyed material
Injuries due to falling objects

Make sure that the belt section has been correctly assembled by qualifi ed
personnel before commissioning it.
Malfunctions due to incorrect assembly and commissioning
The belt section may be damaged or its service life shortened

Commissioning requires basic mechanical, pneumatic, and electrical knowledge.

Only qualifi ed personnel may commission the belt section (see "Personnel
qualifi cations",  7).
7.1 Commissioning for the fi rst time
Start the belt section for a maximum of 2 s and check that the motor is rotating in the
correct direction.
Incorrect motor rotation direction, incorrect direction of transport
The belt section may be damaged or its service life shortened

Exchange any two wires (L1, L2, or L3) to change the motor's rotation direction
( 19, Fig. B).

In motors with a factory-installed plug, correct the direction of rotation in the
switch cabinet or at the plug coupling (socket side). This will simplify exchanges.
TS 2pv 3 842 540 837 (2010.02)