B.how To Add The Battery Tray Kit; How To Remove Battery Tray Components - Sunrise Medical Zippie IRIS Manual De Instrucciones Y Garantía Para El Usuario

32
B. HOW TO ADD THE BATTERY TRAY KIT
1. Loosen and remove the bolts (A) from the rear strut tube. The existing rear strut
tube will not be used in the battery tray setup.
2. Relocation of carriage (when needed, consult customer service)
a. Loosen and remove rear bolt (i) from the carriage on each side.
b. Loosen and remove front bolt (ii) from the carriage on each side.
c. Set the carriage at desired location
d. Replace and tighten bolts
3. Relocation of Axle Plates (when needed, consult customer service)
a. Loosen and remove front and rear bolts from the axle plate on each side, noting
the orientation and holes used on the axle plate.
b. Set the axle plate at new location
c. Replace and tighten bolts. Be sure to use the same orientation and holes in the axle
plate as were being used previously, unless a seat height adjustment is being made.
4. Loosen bolts from both ends of the front strut tube.
5. Place Battery Tray with new middle and rear battery tray struts in proper locations
(consult customer service for proper locations).
6. Replace and tighten bolts (A) into front strut tube and middle and rear strut tube
mounts (G).
NOTE –
Use a torque setting of 96 in-lb when tightening struts, carriages and axle plates.
C. HOW TO REMOVE BATTERY TRAY COMPONENTS
Always contact Technical Service before installing or removing the battery tray
components to obtain the correct assembly locations of the strut tubes, roller
carriage assembly and caster brackets.
1. Loosen and remove the bolts (A) from the middle and rear Battery Tray Strut Tubes.
Relocation of carriage (when needed, consult customer service)
a. Loosen and remove rear bolt (i) from the carriage on each side.
Loosen and remove front bolt (ii) from the carriage on each side.
c. Set the carriage at desired location
d. Replace and tighten bolts
3. Relocation of Axle Plates (when needed, consult customer service)
a. Loosen and remove front and rear bolts from the axle plate on each side, noting
the orientation and holes used on the axle plate.
b. Set the axle plate at new location
c. Replace and tighten bolts. Be sure to use the same orientation and holes in the
axle plate as were being used previously, unless a seat height adjustment is being
made.
4. Install Base Frame Strut (standard strut, not battery tray strut) into proper position
(consult customer service for proper rear strut size and position), and tighten all
strut bolts (A).
NOTE –
Use a torque setting of 96 in-lb when tightening struts, carriages and axle plates.
101510 Rev. A
E n g l i s h
X . B a t t e r y T r a y