Analysis Mode Settings - Adixen H2000 PLUS 5.0 Manual Del Usuario

Analysis Mode Settings

Move between Leak Alarm Level, Leak
GB
Rate Unit, Min. Presentation Time,
Leak Alarm Indications, and Lowest
Frequency. See page 19 and 20.
APC Settings
Programmable controller for valves etc
in external probes. Move between Probe
Type, APC Time A – D and Purge Le-
vel. See page 21.
Display Settings
Move between Contrast, Brightness
and Screen Save Timeout for the dis-
play. See page 22.
General Settings
Various general settings. Move between
Language, Measure/Print Button,
Change Password, Set Clock, Set
Date and Printer Port. See page 23.
The following is applicable to the settings described on this page and
following pages:
- If no setting is made in a menu or its submenus within 60 seconds, the instrument will
revert to the Detection Mode/Analysis Mode/Combined Mode.
- All changes in values are valid only when saved using the Save button.
- Use the Undo button to delete a change in value and revert to the previous setting.
Use the Esc button to browse backwards through the menus to the start position Detection
Mode/Analysis Mode/Combined Mode.
1
Adixen Scandinavia - User's manual H2000 PLUS
Analysis Mode Settings
Esc < >
APC Settings
Esc < >
Display Settings
Esc < >
General Settings
Esc < >
Enter
Enter
Enter
Enter