Apc Settings (H2000 Plus, H2000-P Plus) - Adixen H2000 PLUS 5.0 Manual Del Usuario

APC Settings
NOTE! The APC System is not incorpora-
ted in the battery model H2000-C
The Active Probe Control (APC) system
is a programmable controller used to con-
trol valves etc in active probes. Detailed
information about the APC system can be
found in the Technical Manual and in the
respective probe manual.
Select the main menu APC Settings as
described on page 12.
1. Press Enter.
2. Select:
Probe Type
APC Time A
APC Time B
APC Time C
APC Time D
Purge Level
The timers will have descriptive names
relevant for the probe being used.
3. Press Enter. If Enter Password is dis-
played, this means that the setting function
is protected by a password. See page 29.
4. Choose the desired option or set the
desired value as described in the Technical
Manual.
(5. Press Undo to delete the setting of a
value and revert to previous value.)
.
PLUS
Esc
Esc
Undo
5
6. Press Save to save a set value. The
saved value will flash to confirm the set-
ting.
Revert to Detection Mode/Analysis
Mode/Combined Mode by pressing
Esc twice.
Adixen Scandinavia - User's manual H2000 PLUS
APC Settings
< > Enter
1
APC Settings
APC Time A
< > Enter
2 3
APC Settings
APC Time A
Set Pre fill evacuation
10.0 sec
+ – Save
6
4
GB
1