Change Password; Set Clock - Adixen H2000 PLUS 5.0 Manual Del Usuario

Explanations
GB
Language
Select menu language.
Measure/Print Button
Activates the measure or print button in Analysis Mode. If hand probe is used the
present value is sent to the printer port. Note! Printer Port must be activated. If
active probe is used, pressing Measure starts an active measurement cycle.

Change Password

The most critical parameters can be protected using a password so that the instru-
ment settings cannot be changed by unauthorised users. Note! Factory default is
no password.
When Enter Password is displayed: Type in the password (alpha/numeric cha-
racters) using + and –. Move forward to next character using >. Press > twice after
last character. The display now shows Confirm New Password. To confirm, type
in the password again and press > twice. The display then shows New Password
Accepted.
If no password is required, only press > twice in response to Enter New Password
on the display.
Note! When entering characters, go left to come directly to the digits and press right
to reach the letters (i.e pressing left arrow at start scrolls around to the last character
in the list). This function also works for timer settings.

Set Clock

When Set Time is displayed: Type in the time using + and –. Move forward to next
character using >. Press > twice after last character.
Set Date
When Set Date is displayed: Set year using + and – buttons and press Enter. Select
month using < and > and press Enter. Set day using + and – and press >.
Printer Port
Choose between:
No Printer (printer port disabled)
PC Printer
Analysis Data Output
Detection Data Output
For details see Technical Manual.
ILS 500 v2+ (used in ILS500 system).

Adixen Scandinavia - User's manual H2000 PLUS