Mounting The Deflector; Mounting Cutting Tools - Stihl FS 45 Manual De Instrucciones

English / USA

Mounting the Deflector

2
1
4
: Push the deflector (1) over the
clamp (2).
: Insert nut (3) in the hex recess in the
deflector.
: Make sure the holes line up.
: Fit screw (4) and tighten it down
firmly.
18

Mounting Cutting Tools

3
Preparations
: Lay your trimmer on its back with
the loop handle and shroud pointing
down and the output shaft facing up.
1
3
2
4
Thrust Plate
The thrust plate is shipped with the
Polycut 6-3 and FixCut 5-2. It is only
required for these mowing heads.
AutoCut 5-2 mowing head
AutoCut C 5-2 mowing head
: Pull the thrust plate (1) (if fitted) off
the shaft (2).
STIHL PolyCut 6-3 mowing head,
STIHL FixCut 5-2 mowing head
: Slip the thrust plate (1) over the
shaft (2) and engage hexagon
recess (3) on external hexagon (4).
FS 45, FS 46