Adjusting The Throttle Cable; Mounting The Deflector - Stihl FS 300 Manual De Instrucciones

English
4
► Place the handlebar (4) in the lower clamp (1)
so that distance A is no more than 15 cm.
► Place the upper clamp in position and press it
down.
► Insert the clamping screw.
► Line up the handlebar at a right angle to the
drive tube.
► Tighten down the clamping screw firmly.
7
5
6
56
A
1
8
7
9
4
9

5 Adjusting the Throttle Cable

► Take out the screw (5), the nut (6) remains in
the control handle (7).
► Push the control handle onto the end of the
handlebar (4) until the holes (9) line up – the
throttle trigger (8) must point towards the gear‐
box.
► Insert the screw and tighten it down firmly.
► Go to "Adjusting the Throttle Cable".
Transport and storage position: Loosen the
clamping screw, turn the handlebar in line with
the drive tube and fold the handles down.
5 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
► Set the throttle trigger to the full throttle posi‐
tion.
► Carefully rotate the screw in the throttle trigger
in the direction of the arrow until you feel initial
resistance. Then rotate it another half turn in
the same direction.
6

Mounting the Deflector

6.1 Using the proper deflector
1
0458-579-8721-B