Stihl FS 240 Manual De Instrucciones página 22

English
Fastening the handlebar
A
3
7
Position the handlebar (7) in the
N
lower clamp (1) so that distance (A)
is not more than 15 cm (6 in.)
Place the upper clamp on top and
N
hold both clamps together
Insert the tommy screw (3) through
N
both clamps as far as it will go – hold
all parts together and secure them
20
2
1
Position the entire secured
N
assembly on the handlebar
support (8) with the tommy screw
facing the engine
Press the tommy screw (3) into the
N
handlebar support as far as it will go
and then screw it in – do not tighten
it down yet
Align the handlebar so that it is
N
perpendicular to the shaft – check
distance (A)
Tighten tommy screw
N
3
8
Attaching the control handle
12
11
9
10
Unscrew the bolt (9) – remove the
N
nut (10) from the control handle (11)
Push the control handle with the
N
throttle trigger (12) facing toward
the gearbox onto the end of the
handlebar (7) until the holes (13)
align
Insert nut (10) in the control
N
handle (11), insert the bolt (9) in the
control handle and turn and tighten
the bolt
Fastening the throttle cable
NOTICE
Do not kink the throttle cable or run it in
tight radiuses – the throttle trigger must
move freely!
FS 240, FS 240 R
13
7
13