Balancing The Trimmer/Brushcutter - Stihl FS 240 Manual De Instrucciones

English
Detaching machine from shoulder strap
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing off the machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger. To
throw off the machine, use the
procedure described under "Detaching
machine from shoulder strap". Practice
removing and putting down the power
tool as you would in an emergency. To
avoid damage, do not throw the power
tool to the ground when practicing.
30
Balancing the
Trimmer/Brushcutter
Balancing the machine
The unit is balanced differently
depending on the cutting attachment
used.
Proceed as follows until the conditions
specified under "Floating positions"
have been met:
1 1
2
Loosen the screw (1).
N
Slide the carrying ring (2) along the
N
drive tube.
Tighten the screw moderately.
N
Allow the unit to hang freely.
N
Check the position obtained.
N
Floating positions
Mowing tools such as mowing heads,
grass cutting blades and brush knives
should just touch the ground.
N
Circular saw blades
should "hover" about 20 cm (8 in)
N
above the ground.
When the correct floating position has
been reached:
Tighten down the screw on the
N
carrying ring firmly.
FS 240, FS 240 R