Storing The Machine; Sharpening Metal Cutting Blades - Stihl FS 240 Manual De Instrucciones

Storing the Machine

If the machine is to remain out of use for
approx. 3 months or more
Drain and clean the fuel tank in a
N
well ventilated place
Dispose of fuel in accordance with
N
the regulations and having regard
for the environment
Run the engine until the carburetor
N
is dry. This helps to prevent the
carburetor diaphragms sticking
together.
Remove, clean and inspect the
N
cutting attachment. Treat metal
cutting attachments with protective
oil.
Thoroughly clean the machine
N
Store the machine in a dry and safe
N
place, out of the reach of children
and other unauthorized users
FS 240, FS 240 R
Sharpening Metal Cutting
Blades
Use a sharpening file (see "Special
N
Accessories") to sharpen dull
cutting attachments. In case of
more serious wear or nicks:
Resharpen with a grinder or have
the work done by a dealer – STIHL
recommends a STIHL servicing
dealer.
Sharpen frequently, take away as
N
little metal as possible – two or three
strokes of the file are usually
enough.
1
2
1
2
Resharpen the teeth (1) uniformly –
N
do not alter the contour of the parent
blade (2) in any way.
See cutting attachment packaging for
additional sharpening instructions. Keep
the packaging for future reference.
Balancing
After resharpening about 5 times,
N
check the cutting attachment for
out-of-balance on a STIHL balancer
– see "Special Accessories" – or
have it checked by a dealer and re-
balanced as necessary – STIHL
recommends a STIHL servicing
dealer.
1
2
English
41