Stihl FS 240 Manual De Instrucciones página 27

Mounting Hardware for Cutting
Attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
If mounting hardware is not packed with
machine
2
Only mowing heads may be used which
mount directly to the shaft (2).
If mounting hardware is packed with
machine
Mowing heads and metal cutting
attachments may be mounted.
FS 240, FS 240 R
3
4
5
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Block the shaft.
2
7
6
The output shaft (2) must be blocked
with the stop pin (6) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
Insert the stop pin (6) in the bore (7)
N
in the gearbox as far as stop, apply
slight pressure.
Rotate shaft, nut or cutting
N
attachment until the stop pin slips
into position and blocks the shaft.
Mount the cutting attachment.
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
6
English
25