Basic Cleaning; Troubleshooting - Abicor Binzel AUT-WIG 20G Instructivo De Servicio

10 Troubleshooting

9.1 Basic cleaning

10 Troubleshooting
Problem Cause
No welding • Power supply to the work-piece or torch
interrupted
arc
• Power supply defective
• Contactor not activated in the power
supply
Tab. 7 Troubleshooting
EN - 14
Fig. 4
Sharpening the tungsten electrode
To sharpen the tungsten electrode, use a sharpening device with a diamond
wheel. In doing so, observe the following:
• The point is sharpened longitudinally through the centre axis.
• Automatic regulation of the tungsten electrode drive by gravity.
• Can be set for all electrode diameters.
• Continuous adjustment of the angle.
We recommend basic cleaning once a week. The type and frequency of
cleaning shall be determined and established by the system operator of the
welding system.
NOTE
• Some problems are listed below, with descriptions of possible causes and
solutions. If the measures described below are not successful, please
consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as power supply, re-circulating cooling device.
Solution
• Close the power circuit
• Repair
• See operating instructions for the
power supply
AUT-WIG