Maintenance And Cleaning - Abicor Binzel AUT-WIG 20G Instructivo De Servicio

AUT-WIG

9 Maintenance and cleaning

Regular and lasting maintenance and cleaning are the prerequisite of a long
life and trouble-free operation.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Disconnect the gas supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Check coolant hoses, seals, and connections for damage and tightness.
Replace as necessary.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
The parts of TIG welding torches listed below are subject to wear and soiling.
This is why these parts must be subjected to regular maintenance and cleaning.
Sharpening the tungsten electrode
Sharpening the tungsten electrode depends on wear and must therefore be
carried out when required.
NOTE
• The length of the electrode tip should be about 1-1.5 times the electrode
diameter.
9 Maintenance and cleaning
EN - 13