Orbegozo FDI 94 Manual De Instalación página 47

FDI 94 FDI 124 FDI 184 FDI 244 MANUAL DE INSTALACIÓN
Refer to the following diagram to ensure proper distance from walls and ceiling:
STEP 2: ATTACH MOUNTING PLATE TO WALL
The mounting plate is the device on which you will mount the indoor unit.
1. Remove the screw that attaches the mounting plate to the back of the indoor unit.
2. Place the mounting plate against the wall in a location that meets the standards in the Select
Installation Location step. (See Mounting Plate Dimensions for detailed information on mounting plate
sizes.)
3. Drill holes for mounting screws in places that:

have studs and can support the weight of the unit

correspond to screw holes in the mounting plate
4. Secure the mounting plate to the wall with the screws provided.
5. Make sure that mounting plate is flat against the wall.
NOTE FOR CONCRETE OR BRICK WALLS
If the wall is made of brick, concrete, or similar material, drill 5mm-diameter (0.2in-diameter) holes in the wall
and insert the sleeve anchors provided. Then secure the mounting plate to the wall by tightening the screws
directly into the clip anchors.
47