Orbegozo FDI 94 Manual De Instalación página 54

FDI 94 FDI 124 FDI 184 FDI 244 MANUAL DE INSTALACIÓN
8. After checking to make sure every connection is secure, use the cable clamp to fasten the signal cable to the
unit. Screw the cable clamp down tightly.
9. Replace the wire cover on the front of the unit, and the plastic panel on the back.
NOTE ABOUT WIRING: THE WIRING CONNECTION PROCESS MAY DIFFER SLIGHTLY BETWEEN UNITS.
STEP 7: WRAP PIPING AND CABLES
Before passing the piping, drain hose, and the signal cable through the wall hole, you must bundle them
together to save space, protect them, and insulate them.
1. Bundle the drain hose, refrigerant pipes, and signal cable according to following picture:
DO NOT INTERTWINE SIGNAL CABLE WITH OTHER WIRES While bundling these items together, do not
intertwine or cross the signal cable with any other wiring.
2. Using adhesive vinyl tape, attach the drain hose to the underside of the refrigerant pipes.
3. Using insulation tape, wrap the signal wire, refrigerant pipes, and drain hose tightly together. Double-
check that all items are bundled in accordance the previous picture.
DO NOT WRAP ENDS OF PIPING: When wrapping the bundle, keep the ends of the piping unwrapped. You
need to access them to test for leaks at the end of the installation process.
STEP 8: MOUNT INDOOR UNIT
If you installed new connective piping to the outdoor unit, do the following:
1. If you have already passed the refrigerant piping through the hole in the wall, proceed to Step 4.
2. Otherwise, double-check that the ends of the refrigerant pipes are sealed to prevent dirt or foreign
materials from entering the pipes.
3. Slowly pass the wrapped bundle of refrigerant pipes, drain hose, and signal wire through the hole in
the wall.
4. Hook the top of the indoor unit on the upper hook of the mounting plate.
5. Check that unit is hooked firmly on mounting by applying slight pressure to the left and right-hand
sides of the unit. The unit should not jiggle or shift.
6. Using even pressure, push down on the bottom half of the unit. Keep pushing down until the unit
snaps onto the hooks along the bottom of the mounting plate.
DRAIN HOSE MUST BE ON BOTTOM
Make sure that the drain hose is at the
bottom of the bundle. Putting the drain
hose at the top of the bundle can cause
the drain pan to overflow, which can
lead to fire or water damage.
54