Using The Pre-Set Programmes - Kenwood CCL45 Instrucciones

using the pre-set programmes

Select the programme
1 Press the desired programme button.
Note: When the programme button is pressed, the bar
above the relevant button will light up.
2 Press the (+) or (-) button to select the required
sub-programme.
Then press the OK button to confirm selection.
3 Follow the instructions on the display screen and refer to
the relevant recipe.
4 Press the Start/Stop button.
Adjusting the sub-programmes
During each stage the temperature, time and speed settings can be adjusted if required. Press the Start/
l
Stop button and select the setting to be adjusted. Use the (+) and (-) buttons to change the setting,
k
then press the Start/Stop button to resume cooking.
Use the spatula supplied to scrape down the ingredients in between each stage.
l
The number of available stages for each sub programme varies. The table below shows the range of
available temperature, time and speed settings for each stage.
Stage
1–4
Temperature Range
30°C - 180°C
Time Range
5 secs – 8 hrs
15
Speed Range
1 – 12