Babyauto ZARAUZCON fix 123 Manual De Uso página 11

installing the Top Tether
Look for this symbol
in your vehicle.
1. Take the Top Tether. Lengthen the strap if necessary by
pressing the Top Tether brake button
2. Attach the Top Tether hook to the Top Tether anchorage point
which is recommended in the owner's manual for your car (fig.
3.6).
3. To tighten the Top Tether, remove any slack by pulling on the
free end of the strap until it is suitably tightened. The Top
Tether will be properly tightened when the tension indicator
turns completely green (fig. 3.7).
4. fAsteNiNG tHe CHild iNtO tHe seAt UsiNG tHe
5 POiNt HARNess. GROUP 1.
NOtifiCAtiON
NOte! do not pull the shoulder pads.
1. Loosen the harness straps by pressing the release button and
pulling the harness straps as far as you can. (fig. 4.2).
2. Open the harness buckle, (fig. 4.3) then place the harness straps
to the sides of the car seat. Put the baby into the car seat.
20
(i) to release the strap.
Only for use with Group 1 from
approx. 9 months to 4 years of
age (9-18 kg)
3. The correct belt height of the shoulder pads is attained when
the strap disappears into the shell slightly above the shoulder
of the child. Make sure that the harness straps fit properly over
the shoulders of the child (fig. 4.1).
4. Sidle buckle tongues together and insert them in the buckle
with an audible sound "click" (fig. 4.4).
5. Do not twist or interchange the harness straps.
6. Pull the straps tight by the harness adjustment strap, and make
sure the tightness is comfortable to your kid (fig. 4.5).
5. AdJUstmeNt/RemOViNG tHe 5-POiNt HARNess sYstem
ANd COVeR
1. Press adjusting device and pull harness strap towards as far
as you can (see page. 8). Open the cover snap button at the
bottom of seat back as shown right picture.
2. Loose the harness strap and pull strap out off the strap yoke
(fig. 5.1).
3. Pull two harness straps out off cover slot, then separate strap
with buckle metal connector (fig. 5.2, 5.3).
4. For harness height adjustment, insert the harness shoulder belts
through the desired holes and reinsert then to the connector
on the back.
5. For removing the harness, after above steps, draw whole strap
out from the bottom of seat. Rotate buckle clip to the shown
position, (fig. 5.4) then take it out from seat base. (fig. 5.5).
6. Remove the 5-point harness system then remove the headrest
cover and the shell cover.
7. To install 5-point harness system follow the previous fixes in
reverse order.
21