Publicidad
Idiomas disponibles
Idiomas disponibles
BML-S1H1/2-B/S6 _ C-M3_ _ -D0-KA _ _ , _ -S284
Absolute Magnetic Linear Encoder
EU Directive 2004/108/EG (EMC Directive) and EMC law
Noise immunity: EN 61000-6-1/EN 61000-6-2
Emission: EN 61000-6-3/EN 61000-6-4
Intended use
The BML magnetic linear encoder is intended for
communication with a machine control (e.g. PLC). It is
intended to be installed into a machine or system. Flawless
function in accordance with the specifications in the
technical data is ensured only when using original
BALLUFF accessories. Use of any other components will
void the warranty. Non-approved use is not permitted and
will result in the loss of warranty and liability claims against
the manufacturer.
Downloading further instructions
A complete user's guide and the magnetic tape user's
guide can be downloaded from the Internet at
www.balluff.com/downloads-bml or requested via
e-mail from service@balluff.de.
Installation and connection
~49
23
Left
Rear
9
Right
Active measuring
surface
20
1
Start of
magnetic tape
Left
www.balluff.com
2
10
1)
mastertrack
7
6
2
2
Front
8
mastertrack
7
Active measuring
surface
Right
Rear
1) Note the orientation of the mastertrack!
(Note: Bonded magnetic tape should not be removed,
even partially.)
2) Magnetic tape is not included in the scope of delivery.
general safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the linear encoder will
not result in hazards to persons or equipment.
If defects and unresolvable faults occur in the linear
encoder, take it out of service and secure against
unauthorized use.
Sensor head
R5
3
2×M4
12
40
Measuring range
2)
Measuring range
2)
1)
File no.
E227256
6
14
(shown without
plug)
Active measuring
surface
End of
magnetic
tape
english
1
Publicidad
