Filling With Water; Adjusting The Outlet For Coffee Beverages; Emptying The Drip Tray And Coffee Grounds Container - melitta Purista Serie Manual De Instrucciones

prepared and the display stops flashing.
The Ready display and the Coffee beans
display light up.

4.3 Filling with water

Only use fresh, cold water without carbon
dioxide for optimum coffee enjoyment.
Change the water daily.
Information
The quality of the water largely deter-
mines the flavour of the coffee. Therefore,
use a water filter (see section 6.3 Setting
the water hardness on page 41 and sec-
tion 7.5 Using a water filter on page 48).
The Water display lights up and
requests you to refill water.
2
1
Fig. 6: Removing the water tank
1. Open the lid (2) of the water tank (1)
and pull the water tank upwards out of
the appliance by the handle.
2. Fill the water tank with water.
3. Insert the water tank into the appliance
from above and close the lid.
4.4 Adjusting the outlet for
coffee beverages
The outlet (6) is height-adjustable. Set the
greatest possible distance between the
outlet and the vessel. Depending on the
vessel, push the outlet up or down.
Fig. 7: Adjusting the outlet for coffee
beverages
4.5 Emptying the drip tray
and coffee grounds
container
When the drip tray (7) and the coffee
grounds container (11) are full, the Drip
tray display lights up and requests you to
empty the container The display appears
after preparing approx. 8 beverages.
The projecting float (12) also indicates that
the drip tray is full.
Always empty both containers. When the
drip tray is pulled out, the Drip tray display
flashes.
Basic operation
6
37