Panasonic WV-CLR930 Manual Del Usuario página 13

r Put the cover on the ALC connector so
that the lens cable is secured to the rib.
c
Fix an optional camera mount bracket onto the desired place and mount the
camera on it.
Use appropriate screws for the ceiling/wall material to secure an optional camera mount
bracket. Method of installation may be different depending on the material of the place
where the camera mount bracket is to be installed.
• When installing on steel:
• When installing on concrete: Fix with anchor bolts (M6 or M8)
(Recommended tightening torque (M6): 5.0 N·m, recommended tightening torque
(M8): 6.2 N·m)
• The following are the requirements of the camera mount bracket installation:
Installing place
On ceiling
On wall
Important:
• If the total weight of the camera and lens exceeds 1 kg, use a housing to take measures
against camera drop.
• When the tripod socket is mounted on
the top of the camera, be sure to use the
screws that were removed from the tri-
pod socket. Use of longer or shorter
screws may cause drop or damage.
(Recommended tightening torque: 0.39
N·m)
Fix with bolts and nuts (M6 or M8)
Appropriate cam-
era mount bracket
WV-7010A
WV-831
Cover
Recommended Number of
screw
M6 or M8
M8
Tripod socket hole:
1/4-20 UNC
Lens cable
ALC connector
Pull-out capacity
screw of a single screw
3 pcs. 196 N
4 pcs. 921 N
Screws
Tripod socket
13