Troubleshooting; Support - Franke FMY 99 P XS Manual De Usuario

REPLACING THE LAMP
• Disconnect the oven from the power supply�
• Unscrew the cover from the light, replace the bulb
and screw the cover back on the light�
• Reconnect the oven to the power supply�

TROUBLESHOOTING

Problem
The oven is not
working�
The display shows
the letter "F" followed
by a number or letter�
The home power
goes off�
The function is not
available in demo
mode�
The door will not
open�

SUPPORT

In the event of any operation problems, contact a Franke
Technical Service Centre�
Never use the services of unauthorized technicians�
Specify:
- the type of fault
- the appliance model (art�/Code)
- the serial number (S�N�) on the rating plate, located
on the right hand edge of the oven cavity (visible
when the oven door is open)�
001
Possible cause
Power cut�
Disconnection from the
mains�
Oven failure�
Power setting wrong�
Demo mode is running�
Cleaning cycle in progress�
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
Do not handle bulbs with your bare hands as your
fingerprints could damage them. Do not use the oven until
the light cover has been refitted.
Solution
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply�
Turn off the oven and restart it to see if the fault persists�
Contact you nearest Client After-sales Service Centre
and state the number following the letter "F"�
Press , tap and then select "Factory Reset"� All
settings saved will be deleted�
Verify if your domestic network has at least a rating of
more than 3 kW� If no, decrease the power to 13 Ampere�
To change it, press
select "Power Management"�
Press , tap "Info" and then select "Store Demo
Mode" to exit�
Wait for the function to finish and for the oven to cool
down�
When contacting our
Service Centre, please
state the codes provided
on your product's
identification plate�
, select "More Modes" and then
XXXXXXXXXX
Model: xxxXXXXxx
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXX
XXX X X X X X XXX XX XXXX X X X
EN
XXXXXX XXXXXX XXXXX XXXXXXX
21