Water Connections; Water Drain - lamber DSP26-ADD Manual Del Usuario

WATER CONNECTIONS

Carefully comply with any
regional regulations in force.
Water installation must have
characteristics:
Temperature: 10÷12 °C (DSP26-DSP3)
Temperature : 55°C (DSP4)
Dynamic Pressure :
2 ÷ 4 bar (200÷400 kPa);
-
-for machines with incorporated Water-
softener:
Dynamic Pressure: 3 ÷ 4 bar (300 ÷ 400
kPa).
Temperature: 10÷12 °C.
ATTENTION!: do
softened water.
WARNING!
If the water pressure is higher than 4 bar, fit
the pressure reducer "A" supplied into the
solenoid valve as shown in the drawing.
If the dynamic pressure is lower than
specified on the data plate of the machine, it
is advisable to install a Booster Pump.
Hardness: between 7,2 and 12,5 °French.
If the hardness values are higher than
those mentioned above, it is advisable to
install a water-softener.
national or
the following
NOT connect to
WORKS TEMPERATURES
Water temperature 55°÷60°C
Rinse temperature 80°÷85°C
DO NOT TAMPER WITH THE
THERMOSTAT CALIBRATION

WATER DRAIN

According to the dimensions of the drawing;
water drain and feeding
the same diameter as the water inlet of the
machine.
It must be furnished with a siphon and have
a right slope.
The machine is provided with a flexible pipe
for the connection with the water-work.
Make sure there are no throttlings along the
pipe.
Carefully comply with any
regional regulations in force.
41
pipe should have
national or