Gold 5/16" Flat Head Screw - Sauder Heritage Serie Manual De Montaje

Z Y
4 4
Push the black lever in and pull the SLIDE from the RAIL.

GOLD 5/16" FLAT HEAD SCREW

(12 used in this step)
3S
Open end
Y
Y
Finished edge
D2
Y
Open end
B
Y
A
Y
Open end
C2
Finished edge
Y
Open end
Separate the EXTENSION SLIDES (Z) from the EXTENSION RAILS (Y) as shown in the upper diagram. Be prepared, the parts are
greasy.
Fasten the EXTENSION RAILS (Y) to the ENDS (A and B) and UPRIGHTS (C2 and D2). Use twelve GOLD 5/16" FLAT HEAD
SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in or out to find the other hole that lines up with the hole in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
402159 www.sauder.com/services
Page 9