Setting Inflation Pressure; Setting Measurement Intervals - Microlife WatchBP office Manual De Instrucciones

Setting inflation pressure

Inflation pressure can be set manually from 140 to
280 mmHg by pressing and holding the Start/Stop
Button for 7 seconds.
Press the M Button to adjust the pressure and press
Start/Stop again to save the setting.
Press and hold
for 7 seconds...

Setting measurement intervals

In 1st Visit and Follow-up Mode, the measurement
intervals of 15, 30, 45 or 60 seconds can be set
manually.
1) Pressing and holding the Start/Stop Button for 3
seconds.
2) Press the M Button to adjust the measurement
interval, then press the Start/Stop Button to
confirm, the meter will go back to stand by Mode.
15 30
45 60
Press and hold
for 3 seconds...
27
EN