Key To Symbols; Symbols On The Machine - Husqvarna 543 XP Manual De Instrucciones

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Never let the guide bar tip come in
contact with any object.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
Chain brake, activated (right)
Chain brake, not activated (left)
Choke lever in "open position".
Choke lever in "closed position".
Air purge.
Refuelling.
2 – English

KEY TO SYMBOLS

Chain oil fill.
Adjustment of the oil pump.
For Canada only:
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max tooth count for the bar
nose sprocket is 10T
- Chain type Husqvarna H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
The engine exhaust from this product
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
XX
XX