Allmand NIGHT-LITE GR Serie Manual Del Operario página 16

Cadena
Ocultar thumbs Ver también para NIGHT-LITE GR Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Use an appropriately sized power cord (not
supplied) depending on the amount of units
used as noted in the following table. Route the
cord through the access hole (B, Figure 15).
Make sure that the circuit breaker (C) for that
power inlet is in the 'ON' position.
15
C
A
Power Cord Size Requirements
Stand-Alone Operation
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-250 ft
0-76.2 m
251-600 ft
76.5-182.9 m
601-1000 ft
183.2-304.8 m
Chained Operation (two units)
First Unit (connected to power source)
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-50 ft
0-15.2 m
51-150 ft
15.5-45.7 m
151-250 ft
46.0-76.2 m
Second Unit (powered by first unit)
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-125 ft
0-38.1 m
126-300 ft
38.4-91.4 m
301-500 ft
91.7-152.4 m
Chained Operation (three units)
First Unit (connected to power source)
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-50 ft
0-15.2 m
51-100 ft
15.5-30.5 m
16
B
D
Cord Size
Imperial
Metric
16/3
1.31 mm²
12/3
3.31 mm²
10/3
5.26 mm²
Cord Size
Imperial
Metric
16/3
1.31 mm²
12/3
3.31 mm²
10/3
5.26 mm²
Cord Size
Imperial
Metric
16/3
1.31 mm²
12/3
3.31 mm²
10/3
5.26 mm²
Cord Size
Imperial
Metric
12/3
3.31 mm²
10/3
5.26 mm²
Chained Operation (three units)
Second Unit (powered by first unit)
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-75 ft
0-22.9 m
76-150 ft
23.2-45.7 m
Third Unit (powered by second unit)
Plug: IEC 60309 (6H)
Cord Length
Imperial
Metric
0-75 ft
0-22.9 m
76-200 ft
23.2-61.0 m
201-300 ft
61.3-91.4 m
Light Tower Operation
Adjusting the Lights
Adjusting The Light Fixtures
Note: The light fixtures must be adjusted before raising
the light tower.
1. Adjust each fixture to the desired position. To adjust
left and right, move the fixture yoke (A, Figure 16).
To adjust up and down, loosen the locking knob (B),
adjust the fixture, then tighten the locking knob.
2. When lighting operations are complete, adjust the
light fixtures to the transport position, with the fixtures
facing straight back toward the rear of the light tower
trailer. See Transporting the Light Tower Trailer.
16
A
B
Cord Size
Imperial
Metric
12/3
3.31 mm²
10/3
5.26 mm²
Cord Size
Imperial
Metric
16/3
1.31 mm²
12/3
3.31 mm²
10/3
5.26 mm²
www.allmand.com

Publicidad

Tabla de contenido
loading

Tabla de contenido