Electrical System - Nilfisk Advance Retriever 350B Instrucciones De Uso Y Despieces

Electrical System

Caution !
Do not reverse the system polarity while connecting the batteries. The polarity reversal damages the electric card 9 (fig 8).
Battery Charge
When the low battery indicator light 6 lites red, re-charge the batteries by the suitable plug 12, fitting it in socket 11 and with 12V - 10A battery
charger.
NOTE: Connect the cables of plug 12 on the battery charger before fitting the plug.
Battery Maintenance
The battery must be always kept clean and dry, including the terminal plugs, bolts, etc... About once a week (according to the walk-behind sweeper
use) remove some caps and check the electrolyte level, topping off with distilled water if necessary.
Occasionally check the charger too. The room where the charge is performed must be ventilated. Do not go near to the battery while charging,
with open flames.
Operating (run) time
The walk-behind sweeper has an operating (run) time that varies depending on the battery type. If the operating (run) time is much lower, check:
1 That the broom is not excessively dragging on the ground.
2 That there are not wire, strings, etc. wound on the main broom or on its sides, thus creating friction and causing an overload.
3 That the battery is fully charged at the start of sweeping.
Fig. 8 - Wiring Scheme
1-5 Clamps
6 Low Battery Pilot Light
7 Starting Key
8 Motor 12V - 250W
9 Electric Card
10 Plug
11 Socket
12 Cable For Battery Charger
13 Battery 12V - 105AH
14 Shaker motor
15 Shaker push button
Fig. 8 - Esquema de la
Instalación Eléctrica
1-5 Bornes
6 Luz indicadora batería descargada
7 Llave encendido
8 Motor eléctrico 12V - 250W
9 Ficha eléctrica
10 Enchufe
11 Toma del enchufe
12 Cable para cargar la batería
13 Baterías 12V - 105AH
14 Motor eléctrico vibrador
15 Pomo vibrador
25 - FORM NO. 041324 / RETRIEVER 350B
Abb. 8 - Elektrischer Schaltplan
1-5 Klemmen
6 Leuchte für entleerte batterie
7 Anlasserschlüssel
8 12V - 250W Elektromotor
9 Elektrokarte
10 Stecker
11 Steckdose
12 Batterieladekabel
13 12V - 105AH Batterien
14 Elektromotor des rüttlers
15 Rüttlerknopf
F2.5A
1
4
F40A
5
15
revised 12/96
Fig. 8 - Schéma Installation Électrique
1-5 Bornes
6 Témoin de batterie déchargée
7 Clef de demarrage
8 Moteur électrique 12V - 250W
9 Carte électrique
10 Fiche
15
F40A
F2.5A
14
11 Prise
12 Câble pour chargeur des batteries
13 Batteries 12V - 105AH
14 Moteur électrique du vibreur
15 Bouton vibreur
14
13