Install The Brush (Disc System) - Nilfisk Liberty SC50 Instrucciones De Uso

A - ENGLISH

INSTALL THE BRUSH (DISC SYSTEM)

1 Verify which brush or pad is appropriate for the floor surface to be cleaned.
2 Make sure the Scrub Deck (8) is in the RAISED position. Make sure the Power Switch (B) is off.
CAUTION !
Turn the machine OFF at the power switch and remove the SmartKey, before changing the brush.
See Figure 2-4. From the right side of the machine, rotate the Squeegee Assembly (11) towards the left side of the machine to create better
3
access to the brush, (AA).
Lift the Scrub Deck Skirt (AB) up and slide the brush under the scrub deck.
4
5 If using a pad, install the pad on the pad holder. It uses a central locking device.
6 To mount the Brush (AC) (or pad holder) lift the brush and align the Lugs (AD) on the brush with the holes on the mounting plate then turn to
lock in place (from the right side of the machine, turn the outside edge of brush towards the rear of machine as shown (AE)). NOTE: During
operation the brush should rotate in direction (AF).
FIGURE 2-4
AA
AB
AE
A - 26
INSTRUCTIONS FOR USE
8
AD
Nilfisk Liberty SC50 - 56091204
11
AC
AF
2/2019