Kalorik EPCK 40911 Manual Del Usuario página 19

Fax +1 305 430 9692

TROUBLESHOOTING
If you have not added sufficient liquid and you notice that the
floating valve has not risen, but the timer is counting down, perform
the following steps:
 Stop the pressure cooker by pressing the "Start/Stop" button
 Turn the pressure regulator knob to Steam, using short bursts, until
the pressure is fully released.
Remove the lid and add approximately 1 cup of water/stock or

any liquid. Stir food to disperse liquid.
 Replace the lid and lock into position.
 Press the setting pressure button. The display will show the preset
pressure of 15 psi. Press "+" or "-" buttons to select the desired
pressure of High, Medium or Low. Press setting pressure button,
the display will show the preset duration of 10 (this equals 10
minutes of cooking time). Press the "+" or "-" buttons and set the
desired time
 Press the "Start/Stop" button to begin cooking again.
If steam is leaking form under the cover because the cover is not
properly closed, the gasket isn't positioned properly or is damaged,
or the pressure cooker is over-filled, follow these steps:
 Unplug. Release any pressure using the quick release method.
 Remove the gasket and check for tears or cracks.
 Check to be sure that the gasket is positioned properly.
 If the cooker is too full, remove excess liquid and continue
cooking.
If you can't open or remove the cover:
 Be sure all of the pressure has been released.
 If you still cannot open it, bring the contents of the cooker up to
pressure again.
 Release the pressure completely and try again.
If you cannot hear steam escaping during the cooking:
This is perfectly normal. Unlike a manual pressure cooker that relies on
constant heat and constant release of the pressure to maintain
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
19
Assembly page 19/64
special instruction from
Print only
EPCK 40911 - 160822
Team