SCHUBERTH S1 PRO Manual página 35

D. THE HELMET
REPLACING THE VISOR SHIELD
Changing the visor screen is easy to do without tools with the
convenient EasyChange visor mechanism. To replace the visor, it is
helpful to place the helmet on a fl at surface or on your thighs while
seated.
Removing the visor shield
1. Fully open the visor; this exposes
the operating lever lying on top
of the notch plate that locates
the visor.
2. With the thumb, move the
operating lever in the
direction of the arrow.
3. The T-pegs of the visor are
released and the visor then
springs out of its holder.
4. Repeat the above steps for
the other side of the visor.
70
Fitting a new visor shield
1. Insert the pivot peg of the visor into the
recess provided for it in the visor
mechanism and position the T-peg
directly below the locking elbow.
locking elbow
2. By applying light pressure to the visor
both upwards and towards the helmet,
the locking elbow will slide upwards
and you should hear the T-peg of the
visor click into place.
3. Repeat the above steps for the other
side of the visor.
4. Close the visor and check that the
locking mechanism is working properly.
T-peg
pivot peg
71