Toto REAH03B1U Manual De Instalación Y Del Propietario página 12

Install the Controller
1) Mark screw hole locations for installation fittings
Mounting on the wall
Referring to the "SET-UP DRAWING", determine
the fastening location of the Controller, and with
reference to the "DIMENSIONS", mark the hole
locations for the mounting bracket and anchoring
plate on the wall.
3 - 4
Mounting bracket screw
hole position
9 - 3
/ 6 4
( 2 3
"
0 )
Anchoring plate
screw hole position
Be sure to install product in correct orientation as shown. Otherwise, product will
IMPORTANT!
not function properly.
2) Install
There is a risk of damage when placing the Controller on the floor temporarily.
NOTE
Please line the floor with the cushioning material from the packaging, etc. before starting
work.
1. Remove the top cover from the Controller
(refer to diagram on right).
2. Draw in the power cord and adjust the length as below based on the position of the power
outlet.
INSTALLATION PROCEDURE
(Scale: inch(mm))
5 / 6
Counter
( 9 4
4 "
)
Controller
1 - 7
Ruled line
/ 8 "
( 4 7
)
Securing on the floor
* When installing on the floor, keep at least 2" away
from walls.
Controller
Ruled line
Mounting bracket
screw hole position
Anchoring plate
screw hole position
12
(Scale: inch(mm))
Wall
Floor
Top cover