After Cleaning - Toto REAH03B1U Manual De Instalación Y Del Propietario

MAINTENANCE : FEED INLET FILTER
2. Remove dust from the filter and rinse the flow regulator with water.
Rinse in water and wash
Feed inlet filter
Dust accumulates inside the filter.
Please inspect carefully.
3. Attach the feed inlet filter with the Steel Filter Key.
NOTE
Be sure to install the flow regulator (Otherwise, the product may break down.)
Feed inlet filter

After cleaning

1. Turn on the water supply at the stop valve and
inspect all the connections for any leaks.
2. Insert the power plug.
3. Press the "TANK FILL" switch and check
that water comes out of the spout.
4. Attach the top cover.
5. Press the "HEAT" switch to "ON".
Start heating operation.
The "HEAT" (Green) lights up. During heating,
the "HEATING" (Orange) also lights.
Do not turn on the "HEAT" switch when there is no water in the tank.
NOTE
Dry Firing will occur which could result in malfunction or an accident.
Attention
Be careful not to drop into the
washbasin drain.
flow regulator
*Pay attention to the
direction
31
Flow regulator
3.Close
2
Light up
5
(Top: Orange)
(Bottom: Green)
Rotate clockwise
3