Toto REAH03B1U Manual De Instalación Y Del Propietario página 14

Securing on the floor
We recommend installing in a covered location such as under a counter behind a front panel.
When installed in an exposed location, there is a risk that the Controller may tip over if
NOTE
excessive external force is applied.
< For concrete floor / sub-floor >
Please install wall anchors
< For wood floor / sub-floor >
Please be sure to secure to plywood at least 19/32" (15mm)
thick.
Please prepare and install the included wood screws
(13/64"×1-1/4"(5.1mm×32mm)) and metal washers on-site when
securing.
3. Secure the Anchoring plate to the Controller with
one countersunk tapping screw.
4. Put the Mounting bracket in position and secure it
with two wood screws.
• Please tighten by hand without using a power tool.
NOTE
• Please do not confuse the front and back of the Anchoring plate.
Do not damage the power cord.
Wood screw
(13/64"×1-1/4"(5.1×32))
Front panel
5. Attach the Controller to the Mounting bracket, and fix the Anchoring plate with one
wood screw.
INSTALLATION PROCEDURE
Wood screw
(13/64"×1-1/4"(5.1×32))
Washer (Not supplied)
Mounting bracket
Wall anchor
Washer (Not supplied)
Anchoring plate
Wall anchor
14
Anchoring plate
Countersunk
tapping screw
Countersunk
tapping screw
(5/32"×25/64"
(4×10))
Do not use power tool
Tilt the Controller as shown and mount to the
Mounting bracket.
Push firmly to the end of the Mounting bracket.
(Scale: inch(mm))
Front Back