Cleaning The Filter; Maintenance : Feed Inlet Filter - Toto REAH03B1U Manual De Instalación Y Del Propietario

MAINTENANCE : FEED INLET FILTER

If the feed inlet filter is clogged, the amount of water supplied to the tank will be reduced, causing malfunction
of the equipment. When the amount of hot water coming out decreases, clean the filter as follows.
Before cleaning the filter
1. Press the "HEAT" switch to "OFF"
The "HEAT" light goes off.
2. Remove the top cover.
3. Turn off the water supply at the
stop valve.
When cleaning the feed inlet
filter, turn off the water supply
at the stop valve.
NOTE
There is a risk that water could
spray out, getting household
belongings wet and leading to
property damage.
4. Press the "TANK FILL" switch.
Make sure that the flow of water stops after a little water comes out of the spout.
5. Unplug the power plug.

Cleaning the filter

1. Using the Steel Filter Key
attached to Controller,
remove the feed inlet filter.
Remove feed inlet filter and
water will come out. Use a towel
to absorb the excess water.
1. Light off
Flow regulator
*Do not disassemble
Feed inlet filter
30
1
5
Rotate
counterclockwise
1.Open
4