Toto REAH03B1U Manual De Instalación Y Del Propietario página 15

3) Connect supply hose
Connect the stop valve and the feed inlet with a supply hose.
Before connecting to the feed inlet, be sure to turn on the
water supply at the stop valve, inspect all the connections for
NOTE
any leaks and flush out water to remove debris from the pipes.
Debris that has passed through the filter may get inside the
device, which could result in malfunction or leakage.
• Use a supply hose to connect the Controller and stop valve.
• Do not install the Controller until the piping joints inside the wall have set and
completely cured.
NOTE
• If hot water passes through before the adhesive is dry, the hot water may give off a foul
odor.
• Please be sure to confirm that the adhesive is dry before mounting.
INSTALLATION PROCEDURE
Feed inlet
Supply hose
15
When installing the top cover, please
position the supply hose so that it does
not interfere with installing the top cover.
Stop valve